Small Animal Barrier Kit Instructions

STEP 1.
Arrange the six short tubes(7) with the pre-assembled connectors(3,4) on the ground in the position as shown in diagram. The K connectors(3) go at the for corners of the garden bed. The X connectors(4) go in the middle of the long side of the rectangular garden bed.

STEP 2.
Insert the six long tubes(6) into the pre-assembled connectors. To do this stand the shorts tubes(7) vertically. Insert the twelve screws(11) into each of six connectors on both sides of the short tubes(7) and tighten to affix the long tubes(6).

STEP 3.
Completely flip over the assembled frame and insert the short tubes(7) into the garden stakes in your 4x8 rectangular garden bed. Insert a black cap(5) into the top of the six connectors.

STEP 4.
Open the green net(8) completely. Holding the net in position on the frame (using the tops of the connectors as hooks), affix the net onto the six horizontal tubes. Use four cable ties(10) to the upper horizontal tubes(6) and two ties(10) to the vertical tubes(7). Then affix the net to the timbers of your garden bed using the netting nails(9). Hammer seven nails into each timber. For best results equally space all ties and nails.

OPTIONAL:
To add a Veggie Wall to the corner of the Small Animal Barrier, replace the three short vertical tubes(7) with the vertical Veggie Wall tubes and attach with the 2 K connectors(2) and one X connector(4). Line up the connectors to the predrilled holes on the Veggie Wall vertical tubes and fasten with the screws(11).